4 English reviews written for The Filament ReFill PLA Midnight Black
11 customer reviews in all languages
| 5 stars | | 15 | (51%) |
|---|---|---|---|
| 4 stars | | 1 | (3%) |
| 3 stars | | 4 | (13%) |
| 2 stars | | 4 | (13%) |
| 1 Stars | | 5 | (17%) |
Filter reviews:
-
Was this rating helpful? (1) (0)
-
Rated with 2 out of 5 stars. Probably not worth your time.
You get what you pay for. Technically able to print, but I am getting a lot of clogs on my flashforge adventurer 3, which is otherwise is very reliable. Cheap, but I'd only recommend this if you are doing non-commercial small prints as it's not worth the risk otherwise. Although maybe extruder and/or setting tweaks might make it reliable enough? Most clogs does seem to happen between prints.
Was this rating helpful? (1) (0)
-
Rated with 1 out of 5 stars. 1.9MM
If i could post the foto, this filament is irregular, i messure it and its allways between 1.8 to 1.9mm its impossible to print so 1kg go to trash! Never used a filament like this, just dont buy it
Was this rating helpful? (2) (0)
-
Rated with 1 out of 5 stars. Respool!
I have ordered this filament in a few colors and so far every spool has had problems after loading it into the AMS, even after a respool this filament has very bad tolerances causing a non consistent extrusion.
Was this rating helpful? (5) (2)
Magazine Articles:
-
Switzerland: Free standard delivery from CHF 69.90
-
Delivery in 3 business days.
More than 11.600 products
We deliver worldwide to
more than 40 countries
Good but not excelent
It's pretty good for being so cheap, but the coil is wound really badly, and often causes problems.